What is a Mitsubishi L200 KA airbag control unit?
The Mitsubishi L200 KA airbag control unit is your vehicle's central safety unit, continuously monitoring sensor data and precisely controlling the deployment of airbags and seatbelt pretensioners in the event of an accident. It also stores important crash data and trouble codes to enable quick and accurate diagnostics and ensure occupant safety.
This electronic control unit, also known as the SRS control unit, is crucial for the passive safety of the Mitsubishi L200 (model years 2005-2015). It is specifically tailored to the vehicle electronics of the L200 KA and requires professional installation.
The module does not have a pre-programmed VIN code when shipped. Adjustment during replacement or reprogramming at a Mitsubishi dealer is often necessary to deactivate the airbag warning light.
Why is the Mitsubishi L200 KA airbag control unit defective?
The Mitsubishi L200 KA airbag control unit often fails when crash data is permanently stored after an accident, internal electronic damage occurs, or wiring harness errors disrupt communication. This usually results in the airbag warning light remaining permanently illuminated and can impair the function of the entire safety system, making repairs necessary.
A failure can be caused by voltage spikes, water ingress, or aging components that "break" the system. Control units often store irreversible crash data after an impact, necessitating a reset or repair.
There are also known cases of wiring harness errors in the Mitsubishi L200 KA, which can lead to error messages and require professional diagnosis. Professional repair is often a cost-effective alternative to purchasing a new module.
Common error codes for Mitsubishi L200 KA airbag control unit repair
During Mitsubishi L200 KA airbag control unit repairs, specific manufacturer-specific error codes such as B1207 or B1402 are often read, which indicate direct problems with the airbag control unit. These codes help diagnose circuit defects or internal malfunctions, enabling targeted troubleshooting and restoring safety.
- B1207 → Passenger Airbag Indicator Circuit Shorted → Short circuit or defect in the passenger airbag indicator circuit.
- B1208 → LCD Heater → Internal error in the airbag control unit, related to the LCD heater.
- B1209 → Test Mode → The airbag control unit is in test mode or there is an internal test signal error.
- B1300 → Topstack Switch → Internal error in the airbag control unit, related to the topstack switch.
- B1402 → Driver Airbag Squib Grounding Fault → Grounding fault on the ignition cable of the driver airbag (squib), e.g. due to a defective airbag or steering wheel clamp ring.
What part numbers are available for the Mitsubishi L200 KA airbag control unit repair?
For Mitsubishi L200 KA airbag control unit repairs, the OEM part numbers 8635A149 and 8635A231 from Mitsubishi, as well as the alternative OEM number VA2335576 from Bosch or a supplier, are relevant. These numbers guarantee compatibility with the L200 IV / Triton KA/KB from 2005-2015 and are crucial for selecting the correct replacement part or repair service.
The following part numbers are 100% verified and compatible with the Mitsubishi L200 KA Airbag Control Unit (SRS Module):
- **8635A149**: Genuine Mitsubishi part number.
- **VA2335576**: Alternative OEM part number, probably from a supplier such as Bosch.
- **8635A231**: Another genuine Mitsubishi part number.
These part numbers are essential for precise diagnosis and successful repair. Compatibility has been verified for the fourth-generation Mitsubishi L200 model (KA/KB series, manufactured approximately 2005–2015).