What is a Nissan Armada TA60 airbag control unit?
The Nissan Armada TA60 airbag control unit is the central safety unit in the vehicle, activating all occupant restraint systems in the event of an accident. It continuously monitors sensors, stores relevant crash data, and ensures the proper functioning of all airbag modules and seatbelt pretensioners to provide maximum protection.
This SRS (Supplemental Restraint System) module precisely coordinates the deployment of airbags and seatbelt pretensioners. It is crucial to the passive safety of the Nissan Armada TA60 and a critical component of the vehicle.
Why is the Nissan Armada TA60 airbag control unit defective?
A Nissan Armada TA60 airbag control unit often fails because it stores crash data after an accident, triggering a fault condition, or it can be affected by power surges, water damage, or age-related electronic failures. This then causes the airbag warning light to activate and the safety system to deactivate.
The most common cause of a defect is the deployment of the airbags in an accident, which locks the control unit. It then stores irretrievable crash data, necessitating a reset or repair of the module.
Electronic components can wear out over time or be damaged by voltage fluctuations. Moisture or corrosion, especially if installed in an unfavorable position, can also damage the module and impair its functionality.
If the control unit detects an internal fault, the airbag warning light in the dashboard will illuminate continuously. A professional diagnostic visit at a workshop is essential to determine the exact cause of the failure and plan the Nissan Armada TA60 airbag control unit repair.
Common error codes for Nissan Armada TA60 airbag control unit repair
During Nissan Armada TA60 airbag control unit repairs, specific error codes may occur that directly indicate problems with the airbag control unit itself, such as internal defects or communication problems. These codes often require a professional reset or repair of the module to restore the safety systems to full functionality.
- **B1239** → Airbag Control Module – defective → Internal error or crash data storage in the control unit.
- **B1414** → Airbag Computer Module Error – Module needs to be reset → Internal module error, often after a crash, requires a reset.
- **B1056** → Driver Airbag Module or SRS Explosive Detonator Circuit Fault → Short circuit or open circuit in the driver airbag ignition line, detected by the control module.
- **U1010** → Airbag Control Unit CAN communication error → Malfunction in the data transmission between the airbag control unit and other vehicle control units.
What part numbers are available for the Nissan Armada TA60 airbag control unit repair?
For Nissan Armada TA60 airbag control unit repairs, the original Nissan OEM part numbers 98820-9GE9A and 988207S606 are primarily relevant, as they are directly verified for the airbag control unit of the specified model. These part numbers ensure exact compatibility and are essential for a professional replacement or reset.
The most important and 100% compatible OEM part numbers for the airbag control unit in the Nissan Armada TA60 (model years approximately 2005–2013) are 98820-9GE9A and 988207S606. These modules are responsible for controlling the airbags and seatbelt pretensioners and must be repaired or replaced if defective.
It is critical that any replacement or repair module be programmed to the specific Vehicle Identification Number (VIN). Otherwise, the airbag warning light may remain active and full functionality of the safety system may not be guaranteed.
Caution is advised with part numbers that refer to other airbag components, such as the driver airbag module (e.g., 98510-9GE8B), as these are not control units. Only the specified control module part numbers should be used for Nissan Armada TA60 airbag control unit repairs. There are no publicly verified OEM part numbers from suppliers such as Bosch or Continental that specifically apply to this Nissan Armada control unit.