What is a Ferrari 812 Superfast F152M airbag control unit?
The Ferrari 812 Superfast F152M airbag control unit is the central safety unit that activates all occupant restraint systems, such as airbags and seatbelt pretensioners, in the event of an accident. It continuously monitors sensors, analyzes collision parameters in real time, and stores important crash data to ensure the safe functioning of passive safety.
This electronic control unit, also called the SRS control unit, is essential for the safety of the occupants in the high-performance super sports car.
It processes signals from various sensors in the vehicle to ensure precise and timely deployment of the airbags if necessary.
Why is the Ferrari 812 Superfast F152M airbag control unit defective?
A Ferrari 812 Superfast F152M airbag control unit is often reported as defective after an accident because it stores crash data and locks up. Internal electronic faults such as short circuits, overvoltage, or memory errors can also cause failure. A professional repair of the control unit is often the most cost-effective solution in such cases.
When an airbag is deployed, the control unit stores a "crash record" and must be reset or repaired before it can function fully again.
Even without an accident, the control unit can fail, for example due to problems with the internal software, the power supply, or aging components. A precise diagnosis helps identify the cause of the fault.
Common error codes for Ferrari 812 Superfast F152M airbag control unit repair
While no 100% verified OEM trouble codes for the Ferrari 81perfast F152M airbag control unit are publicly available, typical B-codes indicate internal control unit issues. These codes occur after an accident or system failure and require specific diagnosis and, if necessary, professional control unit repair.
- **B0091**: Control unit problems → Indicates internal errors or communication problems in the airbag ECU.
- **B1231**: Event threshold exceeded → Occurs when an airbag has been deployed and the control unit registers this.
- **B1239**: Airbag Diagnosis Sensor Unit Malfunction → Indicates a malfunction within the airbag control logic of the ECU.
- **B1499**: SRS-ECU airbag condition monitored, deployed airbag detected → Confirms that the control unit has detected a deployed airbag.
- **65535**: Intermittent error in the internal control unit memory → Indicates a non-reproducible internal error in the airbag ECU.
- **B1620**: Internal Error - Replace SRSCM (Airbag Control Module) → Direct indication of a serious internal defect that requires repair or replacement.
- **Code 01**: Internal ECM (Electronic Control Module) Error → A generic error code for internal problems of the airbag control module.
- **Code 03**: Low Voltage Supply → Indicates problems with the electrical supply to the airbag control unit.
For an accurate diagnosis of the Ferrari 812 Superfast F152M airbag control unit, Ferrari-specific diagnostic tools or official workshop tools are often required.
These specific codes help narrow down the problem and plan the necessary repair or maintenance.
What part numbers are available for the Ferrari 812 Superfast F152M airbag control unit repair?
For the Ferrari 812 Superfast F152M airbag control unit repair, there are no publicly available 100% verified OEM part numbers that clearly specify the control unit. For precise identification, it is essential to request the exact part number directly from an official Ferrari dealer, quoting the chassis number.
The research shows that many listed numbers refer to airbag modules or other components, but not to the central control unit itself.
For example, numbers such as 890777.. or 894611.. were mentioned for airbag modules, which are not control units.
A reference to a possible ECU number 937757 for a Ferrari 812 GTS could not be confirmed as an OEM part number for the F152M control unit.
For the correct Ferrari 812 Superfast F152M airbag control unit repair, the exact part number is crucial to ensure the compatibility of the part to be repaired or replaced.